Spring Loaded Hinges
Select Color
Quick Overview
We have two designs for our spring hinges. One design, called the spring loaded butt hinge, is like our standard hinges; however, there is a spring integrated into the hinge so that the stainless steel spring hinge always returns to the same position. This is really handy when you want the door out of the way when you open the enclosure or if you always want the enclosure door to close itself.
Our second design includes spring loaded pins that can be retracted to remove the hinge from its other half. In many instances it can be desirable to remove the door quickly and easily without having to remove fasteners. Both designs are available in multiple sizes to fit any application you desire. If you have any specific requests, please contact our sales department to see what we can do for you.
They can also be made from steel or stainless steel. Our line of stainless steel spring loaded hinges works extremely well in environments where steel would start to oxidize and eventually degrade the hinge. We use only high quality designs to ensure that our products always exceed your expectations.
GENERAL
The criteria in this guide is based upon yield load and not upon ultimate load (failure). The ratio of ultimate load to yield load is at least 1.5
for all hinges and is a natural safety factor. Impact or shock loads are not included. Additional safety factors should be considered based
on the material requirement. Generally harder materials, or metals, result in stronger hinges.
STRENGTH FACTORS
- Hinges are strongest in horizontal stress when the forces are applied perpendicular to the hinge pin.
- Hinges are weakest in vertical stress when the forces are applied parallel to the pin.
- In horizontal load, the strength per unit of length is constant. The longer the hinge, the stronger it will be.
- In vertical load, strength increases with the square of the length.
- As the hinge leaf thickness increases, hinge strength increases.
- As the diameter of the hinge pin is reduced, hinge strength increases provided the pin diameter is not reduced below twice the thickness of the leaf.
- Under vertical stress, shorter hinge knuckles provide greater strength.
RECOMMENDED SELECTION CRITERIA
- When applicable, use a hinge thickness approximately the same as the material to which the hinge is to be attached.
- Select hinges with the smallest possible knuckle length and having at least 10 knuckles.
- Choose a hinge having the smallest pin diameter (see 3.5) available for the hinge thickness selected.
- Apply a hinge with the knuckles always out if the hinge is to be used under horizontal stress only.
- Lubricating hinges weakens them by a factor of about 25%. Allow a safety factor of 25% if hinges are to be lubricated. Using this application, the strength will not vary with the angle of opening.
.png)
